This case is packed with the BEC board, made for GoPro Lite camera. If you already have has a GoPro HERO 6/7, this is the best choice to make your naked GoPro to be super neat and light. Meanwhile, it can protect your GoPro motherboard well in a heavy crash
BEC Board is specially designed for Naked GoPro Hero which weighs about 1.5g, make your naked GoPro lighter and easier to install on your drone.
The BEC output voltage is 5V@2A, avoid the accident of power off which is caused by the insufficient power supply for the FC board.
Integrated GoPro stock buttons, Power/Mode Button and Record Button.
Integrated GoPro stock LED to know the status of the camera.
Pad is available for pilot to control the GoPro recording via the radio transmitter.
With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.
Item: Case for GoPro Lite Camera
Connector: GH 1.25 3P Connector
How to Assemble
Step 1: Assemble the BEC board on the GoPro motherboard and put the shim 1 and shim 2 to fill small gaps between them.
Step 2: Hold the camera lens and the camera board at the same time, be careful when you assemble the board on the case.
Step 3: Screw the GoPro motherboard with the M1.4*5 screws as shown below
Step 4: Install the carbon fiber board, and screw the board with M1.4*8 screws as shown below.
Step 5: Install the camera lens holder as shown below and screw the camera lens with M1.4*12 screws.
Step 6: Install the ND filter holder and camera board holder to make it done.