Type : Type-C
Baromater : BMP280
OSD Chip : BetaFlight OSD w/ AT7456E Chip
DJI Air Unit Connection Way : Two ways supported: 6-pin connector or direct
6-pin DJI Plug : Supported. completely compatible with DJI O3/Runcam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed
Black Box : 16M Black Box
Current Sensor Input : Supported. For 60A ESC, Please set scale = 180 and Offset = 0
Power Input : 3-6S Lipo
5V BEC Output : 5 grous 5V Output, the total currrent load is 3A
9V Output : 3 groups 9V Output, the total current load is 2.5A
3.3V Output : 1 groups 3.3V Output, maxmum current is 300mA
ESC Signal : M1 - M4
UART : 6 sets (UART2 UART5, UART3), UART6 (Desicated for SBUS) UART4 (Dedicated for ESC telemetry), UART1 (Dedicated for VTX data setting)
Sbs : Debugging to UART6 Channel
ESC Telemetry : UART R4 (UART4)
12C : Supported
LED Pad : Supported
Buzzer : Supported
Supported Flight Controller Firmware : BetaFlight (Defaullt)
Firmware Target Name : STM32F722RET6
Mounting : 30.5x30.5mm (4mm hole diameter)
Dimension : 37x37x6.6mm
Weight : 7.5g

FlashHobby BLS 60A
Firmware : BLS 16.7
PC Configurator Download Link : https://esc-configurator.com/
Continuos Current : 55A*4
Burst Current : 60A (5seconds)
TVS Protective Diode : Yes
External Capacitor : 35V 560uF Low ESR Capacitor (in the package)
ESC Protocol : DSHOT300/600
Power Input : 3-6S LiPo
Power Output : VBAT
Current Sensor : Support (scale=180 Offset=0)
ESC Telemetry : Not Supported
Mounting : 30.5x30.5mm (4mm hole diameter)
Dimension : 42.3x37x6.2mm
Weight : 12g